When it comes to filter products, there are actually a lot of types, especially stainless steel filters are very useful. It can be seen in many fields, such as the recycling of sewage, filtration of waste oil, emulsion treatment, etc. The control part, simplified, stainless steel filter screen, sewage part is an advanced filtering equipment, which has the characteristics of high efficiency and easy operation.

    When installing the stainless steel filter, the control box, sensor and transmission part of the filter must be specially protected. These places are easily damaged. There is a corresponding prompt on the stainless steel filter. After connecting it to the pipeline according to the prompt, debug the electric In part, the direction of rotation of the motor during commissioning must be the same as the specified direction. At the time of installation, it is necessary to pay attention to easy maintenance and install bypass piping. In order to facilitate the placement of debris, the installation should be as far as possible to set the sewage outlet, the length of the sewage pipe should be moderate, and the sewage pipe is connected to the sewage ditch.

    The work of the stainless steel filter will first add the water to be filtered from the water port. After the rough filtering of the first step through the filter screen of the filter, it enters the pipeline for a cycle. After multiple cycles of filtration, most of the impurities in the water are removed The filter is intercepted, but so many impurities are accumulated on the filter, the filter pores will become smaller and smaller, and then the water entering the filter will be too late to pass through the filter, which will filter The filter generates a pressure. When the pressure reaches a certain value, the system generates an electrical signal and transmits it to the control part of the filter. After the control part works through the corresponding system, the dirt is discharged to the outside of the filter through the sewage outlet. This ensures the continuous normal operation of the filter. The stainless steel filter consists of multiple complex parts. In the stainless steel filter housing, there is a horizontal partition that divides the inner cavity into upper and lower cavity. In order to make full use of the filtering space, there are several filter cores in the upper cavity, which can significantly reduce the volume of the filter , The backwash suction cup is installed in the lower cavity of the filter. As soon as the filter works, the sewage first passes through the lower cavity of the filter, and then enters the filter core of the lower cavity of the filter through the partition. Through this series of work, impurities and purified water are separated, and the filtered purified water passes through the upper chamber and is then sent out through the outlet.